68
14 Mounting the Canopy, Cover Caps and the Cover Panels
1568911, Edition 2019-04, Version 0
EN
Figure 48: Mounting the cover caps
14.3 Mounting/dismantling the cover caps to/from the
extension arm
14.3.1 Mounting the cover caps
(See "Figure 48")
The Figure shows the extension arm with motor arm
5
. The installation
procedure for the XL extension arm with motor arm
5
version is identi
-
cal.
The Figure shows a simplified representation with only the extension arm
with motor arm
5
or the XL extension arm with motor arm
5
without ca
-
bles. The detailed representation shows a sectional view of the cover
cap①.
1. When placing the cover cap① onto the extension arm end, make
sure that the holding down clamp② sits in the aperture④.
2. Push the cover cap① onto the extension arm with motor arm
5
or
the XL extension arm with motor arm
5
as far as it will go and
make sure that the latch③ snaps into place in the groove⑤:
•
Make sure that the cables in the extension arm with motor arm
5
or
the XL extension arm with motor arm
5
are not damaged.
•
If properly mounted, the cover cap① can no longer be withdrawn
from the extension arm with motor arm
5
or the XL extension arm
with motor arm
5
.
3. Check that the cover cap① is securely in place:
•
The cover cap① muss be absolutely level with the contours of the
extension arm with motor arm
5
or the XL extension arm with motor
arm
5
.
Figure 49: Dismantling the cover caps
14.3.2 Dismantling the cover caps
(See "Figure 49")
The Figure shows the extension arm with motor arm
5
. The installation
procedure for the XL extension arm with motor arm
5
version is identi
-
cal.
The Figure shows a simplified representation with only the extension arm
with motor arm
5
or the XL extension arm with motor arm
5
without ca
-
bles. The detailed representation shows a sectional view of the cover
cap① .
1. To dismantle the cover cap① push a small, flat screwdriver be
-
tween the cover cap① and the extension arm with motor arm
5
or
the XL extension arm with motor arm
5
and gently push the
latch② out of the groove④.
•
Make sure you do not damage the paint of the extension arm.
•
Make sure you do not damage the latch②.
•
Make sure that the cover cap① neither breaks nor bends.
2. Pull the cover cap① backwards until the holding down clamp③ no
longer engages and the cover cap① can be freely moved.
•
Do not twist the cover cap① and do not remove it with force.
3. Remove the cover cap① towards the top and keep it in a safe
place.
