44
1568911, Edition 2019-04, Version 0
EN
10 Mounting Optional Accessories
Figure 28: Mounting the extension arm lighting
10.1 Mounting the Extension Arm Lighting (for Retro
-
fit only)
(See "Figure 28")
Upon delivery of the system from the factory the following optional
accessories are pre-assembled:
The Figure shows the extension arm with motor arm
5
. The installation
procedure for the XL extension arm with motor arm
5
version is identi
-
cal.
The indirect extension arm lighting
8
(for extension arms from a length
of 800mm possible, for XL extension arms from a length of 1000mm pos
-
sible) is mounted to the top side of the extension arm.
The Figure shows a simplified representation with only the extension arm
with motor arm
5
or the XL extension arm with motor arm
5
without
pre-assembled cables.
1. Dismantle the 3 sealing plugs (not illustrated) from the top side of
the extension arm and dispose of them in compliance with statutory
regulations.
2. Route the connecting cable④ on the basic carrier with LED③
through the mounting aperture⑤ into the extension arm without
bending it.
3. Route the cables through the pendant system and connect them as
described in Chapter 11.5.3 on Page 50.
4. Place the cover① onto the basic carrier with LED③ and screw it on
using 2 countersunk screws M4 x 16mm② – DIN EN ISO 10642.
5. Check that the extension arm lighting
8
is securely in place:
•
The extension arm lighting
8
must be level with the extension arm.
•
The connecting cable④ on the basic carrier with LED③ must sit in
the extension arm.
•
The 2 countersunk screws M4 x 16mm② – DIN EN ISO 10642 must
be screwed on.
