71
1568911, Edition 2019-04, Version 0
14 Mounting the Canopy, Cover Caps and the Cover Panels
EN
Figure 53: Mounting the front side panels to the motor arm
14.7 Mounting the front side panels to the motor arm
(See "Figure 53")
The Figure shows the motor arm
4
. The installation procedure for the
extension arm with motor arm
5
or the XL extension arm with motor arm
5
version is identical.
The Figure shows a simplified representation with only the motor arm
4
without cables.
1. Place the right-hand side cover panel① and insert 2 plastic pins⑤
into the holes⑥ in the motor arm.
•
Make sure that the cover plate④ protrudes into the guide (not illus
-
trated in the Figure) of the side cover panel①.
2. Attach the left-hand side cover panel③ to the mounting fixture② on
the front of the right-hand side cover panel①, route it to the motor
arm and then insert 2 plastic pins⑤ into the holes⑥ in the motor
arm.
3. Make sure that the cover plate④ protrudes into the guide (not illus
-
trated in the Figure) of the side cover panel③.
4. Gently push the 2 straps⑦ at the bottom of the side cover panels in
-
to each other and engage them with each other.
5. Check that the side cover panels are securely in place:
•
The cover plate must slide in the guides (not illustrated in the Figure)
of the side cover panels.
•
The side cover panels must engage tightly with each other without
gaps.
Figure 54: Mounting the front upper cover to the motor arm
14.8 Mounting the front upper cover to the motor arm
(See "Figure 54")
The Figure shows the motor arm
4
. The installation procedure for the
extension arm with motor arm
5
or the XL extension arm with motor arm
5
version is identical.
The Figure shows a simplified representation with only the motor arm
4
without cables.
1. Place the cover① from above and attach one of the 2 axes④ to the
mounting fixture⑤ of the side cover panel.
2. Gently pull the front upper cover① apart and attach the second
axis④ to the mounting fixture⑤ of the side cover panel.
3. Fold down the cover① until the 2 latches② snap into place.
4. Check that the cover① is securely in place:
•
The guides③ of the cover① must sit in the side cover panels.
•
The cover① must sit on the side panels without gaps.
