Novell ZENworks Network Access Control 5.0, User Manual

Page: 276 / 534

276 Novell ZENworks Network Access Control Users Guide
no
vd
ocx
(e
n)
24
Ma
rch 20
09
dot1x port-control auto
sflow-forwarding
!
interface ethernet 3
dot1x port-control auto
sflow-forwarding
!
interface ethernet 4
dot1x port-control auto
sflow-forwarding
!
HP ProCurve 420AP
This section shows how to configure the security settings on the 420AP so that user access may be
controlled using Dynamic VLAN provisioning.
HP ProCurve Access Point 420#configure
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#no ip dhcp
HP ProCurve Access Point 420(if-ethernet)#ip address <IP of Access Point Netmask
Gateway>
HP ProCurve Access Point 420(if-ethernet)#end
HP ProCurve Access Point 420(config)#management-vlan 200 tagged
HP ProCurve Access Point 420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP ProCurve Access Point 420(if-wireless-g)#ssid index 1
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#closed-system
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-authentication-server
address <IP of RADIUS Server>
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-authentication-server
key <Shared RADIUS secret>
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#radius-authentication-server
vlan-format ascii
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#ssid Enterprise420
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#vlan 100 tagged
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#security-suite 6 wpa-wpa2
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#enable
HP ProCurve Access Point 420(if-wireless-g-ssid-1)#end
HP ProCurve Access Point 420(if-wireless-g)#end
HP ProCurve Access Point 420(config)#radius-accounting address <IP of RADIUS
Server>
HP ProCurve Access Point 420(config)#radius-accounting key <Shared RADIUS secret>
HP ProCurve Access Point 420(config)#radius-accounting enable
HP ProCurve Access Point 420(config)#vlan enable dynamic
Reboot system now? <y/n>: y
Dynamic WEP
Enter the same commands as the previous configuration; however, substitute
security-suite
5
instead of
security-suite 6 wpa-wpa2
.
HP ProCurve 530AP
This section shows how to configure the security settings on the 530AP so that user access may be
controlled using Dynamic VLAN provisioning.