CONNECTING
PAGE
|
34
Figure 1-12 Gas purge kit assembly
Connecting
1
Locate the Gas Purge Kit in the i401 ship kit. The kit consists of two each male/female 90° quick-
disconnect fittings, a straight fitting, a low-flow gas filter, and a support bracket with fasteners.
2
Refer to Figure 1-12A and fasten the filter support bracket to the rear of the i401 laser using the 6–
32 Allen cap screws and # 6 flat washers provided in the kit.
3
Assemble the two 90° fittings, straight fitting, and filter as shown in Figure 1-12B. Be sure to orient
the directional arrow on the filter as shown.
4
Loosen the two jam nuts on the straight fitting so it will slide into the support bracket.
5
Refer to Figure 1-12C and plug the filter assembly into the Gas Purge port connector.
