Northern Meditec Crius V6, Operator'S Manual

Page: 96 / 182

96 / 182
5. Press the system switch button,start the system;
6. After LED flash on ISAmonitor flashed sereval seconds turn to normally on means
mearuring state.
7. Sidestream module defaults to standby mode, when connected sidestream module,the
screen will display
【
AG is sleeping
】。
8. Click
【
Menu
】
->
【
System Setup
】
->
【
Gas Module
】：
select
【
Measure
】
,the screen display
【
AG is starting
】
.
7.4.2 Checking before using
Before connecting Nomoline sampling tube to the mask of the patient,please do the following
checking
：
1. Ensure that the you have finished all related operations in Chapter "7.4.1 Installation"
；
2. Exhale to the sampling tube to check if the monitoring interface of the ventilator has
display valid CO2 waveform and value;
3. Use your fingertip to block off the sampling tube,last 10 seconds,should observed on the
anesthetic operation interface display“* Please check the sampling tube”, in the meantime
the red LED light on the monitor flash;
4. In appropriate situation, to check the patient breathing circuit and sealing of the connection
of the sampling tube;
5.
After finish above steps, can connect the Nomoline sampling tube to the patients’ mask or
Y shaped connector.
NOTE

To prevent contaminate operating room, make sure the sidestream gas outlet through
the soft tube connected to the AGSS system.Discharge the exhaust together with AGSS.

The leak of sample gas will cause the measurement accuracy beyond specification;
internal exhaust is not smooth, it may cause the monitor can not working properly.
Therefore, we must ensure the correct connection.