Northern Meditec Crius V6, Operator'S Manual

Page: 124 / 182

124 / 182
O
2
Supply Failure
H
1. Check connection with O2 supply.
2. Check O2 supply pressure.
CO2 communication
stopped
H
CO2 module communication stopped
1. Check if the module is faulty.
2. While removing the ventilation module, unplug the
CO2 module.
3. Please contact your designated service representative.
EtCO
2
Overrange L
Parameter measured values exceed the measurement
range (error range is included).
Perform CO2 module zeroing.
Contact your service personnel.
Oxygen sensor is not
connected
L
Oxygen sensor is not connected.
Please connect the oxygen sensor.
Please Replace O
2
Sensor.
M
The O2 sensor is used up.
Replace the O2 sensor.
Please calibrate O
2
sensor.
L
Calibrate the O2 sensor.
Calibrate O2 concentration.
SPO2 Comm. Stop H
SpO2 module failure, or communication failure
between the module and the host; please restart the
device.
SPO2 Comm. Error
H
SPO2 No Sensor L
SpO2 sensor falls off from the patient or monitor,
malfunctions, or sensor other than specified in this
Manual is used. Check the sensor mounting position,
whether the sensor is damaged or sensor type.
Reconnect the sensor or use new sensor.
SPO2 Sensor Off
L