Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Initial setup
47
213455-L, October 2005
6.
Verify the interfaces are correctly configured:
Allowing SMART Client access to the Firewall
The following procedure gives firewall access to a Check Point SMART Client when the
SmartCenter Server is enabled on the firewall.
1.
At the firewall CLI, log in as admin and enter the following commands:
The command
/cfg/fw/client/add
adds a new member to the list of SMART Clients
that can manage the firewall. SMART Clients interface directly with the Check Point
SmartCenter Server, which interfaces with the firewall. SMART Clients can be implemented
on a separate workstation or on the same workstation as the SmartCenter Server. For other
commands that allow you to delete members or reorder the list, see
/cfg/fw/client on page 363
.
2.
Enter the following command to allow traffic between the Firewall and recently added
SMART Clients.
Allow several minutes for Firewall-1 services to stop before entering the
/cfg/fw/ena
.
3.
Launch the Check Point SmartDashboard to connect to the SmartCenter Server.
>> Access List#
/info/net/if
Interface Information
Id Port VLAN Address Status
== ==== ==== ======= ======
1 3 0 10.3.0.1/16 Enabled
2 4 0 172.25.3.10/24 Enabled
>>
/cfg/fw/client/add 192.168.1.3
<Network Example SMART Client IP
address>
>>
apply
>> Main# apply
>> Main# /cfg/fw/dis
>> Firewall Configuration# apply
>> Firewall Configuration# /cfg/fw/ena
>> Firewall Configuration# apply