Nortel Switched Firewall 2.3.3 User’s Guide and Command Reference
Initial setup
37
213455-L, October 2005
Setting up the basic configuration
The console connection is used to access the Nortel Switched Firewall for performing the
initial configuration.
1.
Connect the console cable and start a console terminal.
Connect the included console cable between the serial port on the Firewall to the serial port of
a computer with terminal emulation software as described in the
Nortel Switched Firewall
5100 Series Hardware Installation Guide
(216382-D).
Press <Enter> on the console terminal to establish the connection. The Nortel Switched
Firewall login prompt will appear. Enter the default login name (
admin
) and the default
password (
admin
). If the Nortel Switched Firewall is set to factory defaults, a special Setup
utility menu appears.
Use the
clone
command to restore the full configuration of a previous setup. The new
firewall is a clone of the original and can replace the original firewall in the network setup. For
more information about cloning, see
Appendix B, Backing Up and Cloning Configurations
on
page 385
.
2.
Select a “new” installation.
login:
admin
Password:
admin
(not displayed)
Switched Firewall
HW platform: NSF 5114
Software version 2.3.3.0_R60
------------------------------------------------------------
[Setup Menu]
clone - Clone the configuration
join - Join an existing SFD cluster
new - Initialize host as a new installation
boot - Boot Menu
info - Information menu
exit - Exit [global command, always available]
>> Setup#
new
>> Setup#
new
Setup will guide you through the initial configuration of the iSD.