Nortek Reznor FSE 100, Installation, Commissioning, Servicing

Page: 20 / 53

PAGE 16 Reznor, FSE, Installation Manual, EN 2020-02, D301160 Iss H
Figure 6 Handling
Installation considerations
The installation location must be
determined by the system designer and/
or by a competent person able to take
into account technical requirements, the
standards and regulations in force.
Generally, special permissions need to be
obtained. (E.g.: regulations con concerning
zoning, architecture, fires, environmental
pollution, noise emission, etc.).
It is important all users have full permission
before the installation can begin.
To properly install the heater,
bear in mind that the heaters
should:
• Be placed on a flat surface, capable of
bearing its weight;
• Be supported over the entire perimeter
of the lower base;
• Be placed on a surface whose deflection
and strength is such that it can prevent
vibrations from reaching underneath;
• Respect the clearance distances in
order to allow for a correct flow of air
and normal cleaning and maintenance
operations;
• Maintain the safety distances from
flammable material;
• Be placed close to a flue chimney;
• Be able to be connected to the fuel
source
• Be close to an electrical socket;
• Allow for easy maintenance and
inspections;
• Be fitted with the ventilation openings
required by the relevant regulations.
It is forbidden to install it:
• In places where there are aggressive
atmospheres;
• In tight spaces where the sound level
of the heater can be increased by
reflections or echoes;
• In corners where leaves could
accumulate or where other objects
could clog the air passage and reduce
the heater efficiency;
• In pressurised places;
• In de-pressurised places;
• Outdoors, if not provided with
protection against bad weather
conditions.