Nortek Reznor FSE 100, Installation, Commissioning, Servicing

Page: 8 / 53

PAGE 4 Reznor, FSE, Installation Manual, EN 2020-02, D301160 Iss H
General
This manual is an integral part of the
heater, therefore it should always be
carefully kept and it should always be
provided together with the heater, if it is
transferred to another owner or user. If
this manual is damaged or lost, a new one
should be requested from the installer or
from the manufacturer. After unpacking
the product, please check the contents to
ensure all components are present. If not,
please contact your supplier.
The installation must be carried out by
suitably qualified personnel who, at the end
of the work, will commission the appliance
and issue to the owner a copy of the
commissioning report, which also confirms
that the installation has been carried out in
accordance with regulations & standards
applicable to the country of use and
in accordance with the manufacturers
instructions.
This appliance has been manufactured
specifically for room heating and must be
used for this purpose. Contractual liability
of the manufacturer in respect of damages
caused to people, animal or premises by
incorrect installation, settings, maintenance
or by improper use of the heater is
excluded.
During the initial start-up, there may be
the formation of odours and fumes due
to the evaporation of the oil added to
protect the heat exchanger during storage;
this is normal and will disappear after a
short period. It is recommended to ensure
suitably ventilation for room.
WARNING
If the appliance is to remain
unused for long periods, it is
recommended that the following
operations are carried out:
• Turn the appliances’ electrical supply off
via the local isolator.
• Close the main fuel supply valve
If there is a long period of time between
operation, it is recommended that you
contact your installer to carry out the new
start-up.
The heater shall be fitted with approved
accessories only. The manufacturer is
not liable for damages arising from the
improper use of the heater or from the use
of non-original materials or accessories.
References to Laws, Regulations, Directives
and Technical Rules mentioned in this
manual are provided only for information
purposes and are in force when the manual
is printed.
The introduction of new provisions
or amendments to current laws does
not represent an obligation of the
manufacturer towards third parties. Repairs
or maintenance are to be performed by
trained personnel only.
Do not modify or tamper with the
appliance, the manufacturer will not
be held responsible for any third party
modifications to the heater.
The services that are to be connected (fuel
pipes, power supply, etc.) must be suitably
secured and must not be hazardous with
the risk of tripping.
The manufacturer is responsible for the
product compliance with Laws, Directives
or Construction Rules in force when the
product is marketed. The knowledge and
observance of the laws and standards
regarding plant design, installation,
operation and maintenance are the sole
responsibility of the designer, installer and
user. The manufacturer shall not be held
responsible for failure to comply with
the instructions of this manual, for the
GENERAL