Nokia M11 T66220, User Manual

Page: 64 / 169

Management
E
Copyright Nokia Networks Oy C33833001SE_00
5-9
6. Enter RIP settings for the Ethernet interface.
Rip-send and Rip-receive radio buttons are used to enable
dynamic routing using Routing Information Protocol (RIP). RIP
and RIP version 2 can be used. RIP-send with V1-compat option
enables the sending of RIPv2 packets using broadcast.
RIP-receive with V1-compat option accepts both RIPv1 and
RIPv2 packets.
7. Enable/disable routing between ATM VCCs (Routing Policy).
IP forwarding and dynamic route distribution between ATM VCC
routing can be switched off when multiple VCCs are used.
8. Enable/disable default gateway.
The default gateway is the host to which your M11 will send a
packet when it does not know how to reach the packet’s
destination host.
9. Select the default gateway port from the Interface list.
The default gateway port can be one of the active PPP channels or a
specified IP address defined in Default Address field (see step
10.).
10. Set an IP address (Default Address) for your default gateway if you
selected “ip-address“ in step 9.
11. Enter domain name server settings.
A domain name server is a network computer responsible for
matching host names to numeric IP addresses so that network
traffic can be routed correctly. These fields are set if DNS
addresses are not allocated dynamically. Consult your service
provider for further assistance.
Domain names identify organisations on the Internet. The domain
name is usually the domain name of your company or your ISP.
If a secondary name server address is configured, M11 relays the
name service request to that server whenever the primary name
server is unavailable.