Nokia M11 T66220, User Manual

Page: 124 / 169

Management
E
Copyright Nokia Networks Oy C33833001SE_00
5-69
Command Enable/disable RIP receive function on channels
using PPP over ATM encapsulation in bridged
mode
Description Specifies whether M11 should use Routing information
protocol (RIP) broadcasts to update its routing tables
with information received from other routers on the
other side of the specified ATM link using PPP over
ATM encapsulation in bridged mode.
Syntax set ip wan {vccx} rip-receive [off | v1 | v2 | v1-compat]
Arguments The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using PPP
over ATM encapsulation in bridged mode, you can
leave the argument
vccx
out. Both RIP version 1 and
RIP version 2 functionalities can be simultaneously acti-
vated.
v1-compat
argument enables the receiving of
both RIPv1 and RIPv2 packets. RIP cannot be acti-
vated if address mapping is ON.
Example
M11> set ip wan vcc2 rip-receive off
Command Enable/disable the management through channels
using PPP over ATM encapsulation
Description Enables/disables the management of M11 through the
specified ATM link using PPP over ATM encapsulation.
Syntax set ip wan {vccx} admin-disable [on|off]
Arguments The first argument identifies the ATM channel (vccx,
x = 1 ... 8). If there is only one ATM channel using PPP
over ATM encapsulation in bridged mode, you can
leave the argument
vccx
out. The second argument
disables/enables management through ATM channel
using PPP-vcmux encapsulation.
Example
M11> set ip wan vcc2 admin-disable on
Static route settings
A static route identifies a manually configured pathway to a remote
network. Unlike dynamic routes, which are acquired and confirmed
periodically from other routers, static routes do not time out.
Consequently, static routes are useful when working with PPP, since
an intermittent PPP link may make maintenance of dynamic routes
problematic.