Parameter Setting
OCM F - rev. 05 / 06.04.2018
page 53
Sensor type
No.
Pressure
01
Level measurement by a KDA combi sensor which is directly con-
nected to OCM F according Fig. 14-5.
Offset installation e. g. due to sedimentation or high dirt load is
possible. Level measurement in case of flooding is possible as
well.
1
Sedimentation or soiling
Fig. 23-13 Sensor type 1: Pressure
Sensor type
No.
Constant
level
02
Use this point to set parameters for constantly full filled pipes and
channels. Such applications normally do not require level meas-
urements. The constant filling level must be set under >value< and
is used for flow calculation. This parameter is helpful too at initial
start-up or in case of performing tests without having level values
available.
Fig. 23-14 Sensor type 2: Constant level
Summary of Contents for OCM F
