}
Position the Device out of direct sunlight and away from sources of heat and
ignition.
Please install the Device in a place far away from the High Power Radio or
Radar Station.
Keep the Device far away from water!
Please use the supplied power cord.
1.3
Installation Requirements
The following items are required for installation:
1) Broadband Internet connection
2) Tools and equipment
(1) Broadband modem (optional)
(2) PC with an Ethernet card and TCP/IP installed
(3) Network devices like hub, switch, wireless access point
(4) Network cables
(5) Screwdriver
(6) Power outlet
1.4
Installation Procedure
Follow these steps to install the Device on a flat surface such as a bench:
1) Make sure the Device is powered off.
2) Place the Device upside down on a sturdy, flat bench with a power outlet nearby.
Verify that the bench is well grounded.
3) Remove the adhesive backing from the supplied rubber feet. Attach the four
rubber feet to the round recessed areas on the bottom of the Device.
4) Turn the Device over to make it right side up on the bench.
