8 - FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014
BURNISHING SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
PAD DRIVE DECK LEVEL ADJUSTMENT
NOTE: Install a new pad before performing this adjustment.
1
Put the pad drive deck in the DOWN position.
2
Briefly run the pad drive motor to get a pattern on the floor.
CAUTION!
Do not run pad motor for an extended period without moving machine.
3
Check the pattern on the floor, there should be a full circular pattern with a little more pressure in the rear.
4
See Figure 2. If the pattern is not correct, loosen Locknut (A).
5
Adjust the Adjuster Stud (B) as needed to bring the pad to a perfectly level position. Increasing (lengthening) the distance between
the (2) (C) Ball Joints lowers the front of the pad. Decreasing (shortening) the distance between the (2) (C) Ball Joints lowers the
rear of the pad.
6
Turn Adjuster Stud (B) (3) turns in the direction required to lower the REAR of the pad drive deck and tighten Locknut (A).
7
Test the machine for proper operation.
A
B
FRONT
C
C
revised 2/02
FIGURE 2
