FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014 - 19
WHEEL DRIVE SYSTEM
C
A
E
FRONT
A
A
B
G
F
B
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
DIFFERENTIAL REPLACEMENT
Removal:
1
Follow steps 1-4 in the
Wheel Drive Chain Removal
section.
2
See Figure 4. Remove the six (A) bolts from the three (B) Pillow Blocks.
3
Remove the Differential (C) from the machine.
4
Remove both drive wheels and spacers (if used) from the differential.
5
See Figure 5. Locate and loosen the (D) Set Screws on the (B) Pillow Blocks.
6
Next, using a drift punch and hammer, break the (E) Lock Collars loose. Then, slide the pillow blocks off of the axle shafts.
7
Remove the sprocket from the differential and examine all of the differential components for excessive wear and need of
replacement.
Differential Sprocket Replacement:
8
See Figure 4. Install the sprocket (F) onto differential (C), sliding it over the (4) threaded studs. Start the (4) retaining nuts by hand.
Using a wrench, check to make sure that the screw heads on the opposite side of the differential case are tight. Continuing to hold
a wrench on the screw head, tighten each nut to 10 ft/lbs. torque to retain the sprocket. Again holding each screw head, tighten
all nuts to 15 ft/lbs. torque.
FIGURE 4
D
E
FIGURE 5
revised 2/02
