18 - FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014
WHEEL DRIVE SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
WHEEL DRIVE CHAIN REMOVAL
1
Follow steps 1-6 in
Wheel Drive Chain Adjustment
section.
2
Remove the batteries, see the
Switching Battery Packs (Battery Removal)
section in the
Electrical System
of this manual for further
information.
3
Tip the machine onto its Left side (be careful not to damage the pad drive deck).
4
Locate the master link on the chain and remove chain.
5
Re-assemble in reverse order.
6
Adjust the chain following steps in the
Wheel Drive Chain Adjustment
section.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
WHEEL DRIVE MOTOR REMOVAL
1
Follow steps 1-4 in the
Wheel Drive Chain Removal
section.
2
See Figure 3. Disconnect the brake spring and Brake Link (A).
3
Disconnect motor wire connections.
4
Remove the three (B) bolts.
5
Lift the motor and brake assembly from the top of machine (it may be easier to cut wire ties to get motor past wiring).
6
Re-assemble in reverse order. NOTE: Align the motor and differential sprockets by moving the motor sprocket in or out on the
motor shaft.
FIGURE 3
FRONT
B
B
Wheel Drive Motor
A
Brake Assembly
revised 2/02
