FORM NO. 56043042 / Whirlamatic
™
2700 / BHS 7014 - 15
BURNISHING SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
DUST SHROUD REMOVAL
1
See steps 1-3 of the
Pad Drive Deck Removal
section.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
DUST SHROUD EDGING REPLACEMENT
FIGURE 11
A
B
FRONT
1
See Figure 11. Remove existing Edging (A) by pulling
it away from the Shroud (B).
2
Start at the rear of the Shroud (B) with one end of the
new Edging (A) so that the seam is hidden. Push “U”
channel onto Shroud (B), work edging assembly around
Shroud (B).
3
Check that Edging (A) “U” channel is firmly in place all
around Shroud (B).
revised 2/02
