Nilfisk-Advance SW900, Service Manual

Page: 58 / 137

Electrical and Control System 58 Service Manual – SW900
Machine Check/Setting (Continues)
10 In the battery compartment, lift the rubber mat
(C)
11 Lift the battery charger plate (D)
12 Carefully set the switches (E, F, G) as shown in
the following table to set machine according to
the type of batteries to be installed
Type of battery set on the machine E switch F switch G switch
EXIDE™ OFF OFF OFF
OPTIMA™ OFF ON OFF
DISCOVER™ ON OFF OFF
GEL/AGM (generic) ON ON OFF
WET (all makes) Any Any ON
Set the switch (H) as shown below:
- For batteries having capacity of 150Ah
or higher (discharge in 5 hours) leave the
default setting to OFF (nominal charge
current 25A)
- For batteries having capacity lower than
150Ah (discharge in 5 hours) set H switch to
ON (nominal charge current 15A)
13 Repeat steps 6 and 7 to check that the machine
has been set correctly
14 Reinstall the plate (D) and the floor mat (C).
15 Install the battery case
16 Install the batteries
P200315