Nilfisk-Advance SW900, Service Manual

Page: 36 / 137

Dust Control System 36 Service Manual – SW900
P200270
9 Disconnect the filter shaker connector (N).
10 For disassembling the filter shaker motor (E)
only, remove the four screws (F), then remove
it from its housing by disengaging the inner
eccentric (F)
The eccentric (F) must be firmly locked on the
shaft of the filter shaker motor.
For the complete removal of the motor (E), it is
necessary to disconnect the semiconnector out of
its wiring harness (L)
11 For disassembling the motor (E) with the holder
(O), remove the four screws (P).
12 For disassembly of the motor (E) with its of
the frame (G) electrical filter shaker, remove
the screws (H) and recover the springs (I), the
washers (J) and the spacer bushes (K)
Check the integrity of the disassembled parts
Assembly
13 Assemble the components in the reverse order of
disassembly, and note the following:
- When reinstalling of the spacer bushes (K)
make sure that the same should are flushed
with the machine frame and that the slots
(M) of the frame (G) slide on spacers (K)
After assembling of the frame (G), check that
the frame can slide on the spacer bushes (K)
of the springs (I), overcoming the resistance
of the springs
Electrical Filter Shaker Motor Disassembly/Assembly (Continues)