Electrical and Control System
83
Service Manual – SW900
P200330
10 Check that the arm (H) of the hopper position
switch (I), swings freely on the pin (J),
otherwise:
•
Remove any dirt causing malfunction
•
Loosen the inner locknut (L) and adjust the
screw (K); when the adjustment is complet
-
ed, tighten the locknut (L)
11
If necessary, loosen the screws (M) and adjust
the position of the switch (I) by moving it in
the direction shown by the arrow (N); when the
adjustment is completed, tighten the screws (M).
12
If necessary, remove the screws (M) and
disconnect the electrical connections (O), then
remove and replace the switch (I); then adjust
the hopper position switch (I) (see the previous
steps)
Hopper Position Switch Operation Check, Removal/Installation (Continues)
9 Remove the screws (F) and the left side panel (G)
Summary of Contents for SW900
