Nilfisk-Advance SW900, Service Manual

Page: 51 / 137

Electrical and Control System 51 Service Manual – SW900
Fuse Check/Replacement/Reset (SW900 B)
1 Drive the machine on a level floor and ensure
that it cannot move
2 Turn the ignition key to “0”
Fuse Check/Reset
3 Check one of the following fuses for deactivation:
- (A): 70A fuse (FA), main motor
- (B): 5A fuse (FB), right side broom motor
- (C): 5A fuse (FC), left side broom motor
4 Reset any deactivated fuse, when the component
that caused deactivation has fully cooled down
Various Fuse Check/Replacement
5 Remove the hopper by using its transport handle
and wheels
6 Disengage the front fastener and open the
battery compartment hood
7 Disconnect the battery connector
8 Remove the rear grid after removing the upper
mounting screw and disengaging the fasteners
9 Disengage and open the cover (I), then check the
fuse:
- (J): 30A fuse (F2), battery charger
- If necessary, remove the nuts (D) and replace
the fuse (J) Screw down and tighten the
nuts
P200277