Nilfisk-Advance SW900, Service Manual

Page: 123 / 137

Side Broom System 123 Service Manual – SW900
Note: Brooms with harder or softer
bristles are available. This
procedure is applicable to all
types of brooms.
Warning! It is advisable to wear
protective gloves when
replacing the side broom
because there can be sharp
debris between the bristles.
Note: This procedure refers to the
right side broom removal;
the procedure for the left side
broom is the same.
Disassembly
1 Drive the machine on a level floor and ensure
that it cannot move
2 Lift the side broom until the end of stroke by
using the lever
3 Turn the ignition key to “0”
4 Loosen the knob (A) inside the side broom, then
remove the side broom (B) by disengaging it
from the three positioning pins (C)
Assembly
5 To install the side broom easily, use its lifting
lever by turning it to fully lowered position
6 Install the side broom in its housing and engage
it on its three positioning pins (C), then tighten
the knob (A)
7 If necessary, check the side broom height (see
the procedure in the relevant paragraph)
Removal and Installation
Side Broom Disassembly/Assembly
P200347