SERVICE MANUAL
STEERING AND BRAKING SYSTEM
GB
S30N1100(1)2002-01
101
BRAKE CONTROL CABLE REMOVAL
1.
Drive the machine on a level ground.
2.
Turn the ignition key (10) to OFF position.
3.
By means of a proper lifting system, hook the machine at the front anchorages (33) and lift it 30 cm from the
ground. Then securely fix it in this position.
4.
Remove the nut (A) and the front wheel (B).
5.
Disengage the brake lever (D) lead-in wire (C); if necessary loosen the register (E).
6.
Remove the screw (F) and the pulley (G).
7.
Loosen the registers (E and H) and remove them from their fixing supports.
8.
Remove the screw (E).
9.
Cut the clamp (L).
10. Remove the cable (M) and recover the pulley (G).
11. Install in the reverse order of removal, with the following change:
–
Before the (M) cable installation, screw down the registers (E and H) completely to facilitate the cable
assembly; the first to be registered is (H).
12. Carry out the Brake adjustment as described on the previous pages.
Figure 4
S300124
Summary of Contents for SR 1100 P/B
