SERVICE MANUAL
PETROL VERSION ENGINE
GB
S30N1100(1)2002-01
123
CHECK AND TENSION OF THE BELT FROM THE ENGINE TO THE
DYNAMOTOR
1.
Drive the machine on a level ground.
2.
Turn the ignition key (10) to OFF position and activate the parking brake (17).
3.
Open the hood (21) and fix it with the support rod (36).
4.
Remove the screws (A) and the dynamotor safety guard (B).
5.
Check the proper tension of the belt (C) from the engine to the dynamotor.
The tension is correct when the belt bending value (E) is not higher than 1 mm with a pressure (D) of 20 Kg.
If necessary, adjust the belt tension according to the following steps, from 6. to 11.
6.
Loosen the four screws (F).
7.
Insert a lever (G) in the hole (H), push it in the direction indicated by the arrow until the belt (I) is correctly
tensioned, and then tighten the screws (F).
8.
Lower the hood (21).
9.
Start the engine and let it run for few minutes, then stop it and turn the ignition key (10) to OFF position.
10. Open the hood (21) and fix it with the support rod (36).
11. Perform step 5 again.
12. Carry out steps from 1. to 4. in the reverse order.
Figure 6
S300153
Figure 7
S300154
Figure 8
S300155
Summary of Contents for SR 1100 P/B
