Nidec Control Techniques HVAC Drive H300 HMI Bypass, Installation And Commissioning Manual

Page: 6 / 56

6 HMI Bypass Controller Installation and Commissioning Guide
Section 2 - Installation Instructions
2.1 Receiving
After unpacking the HMI bypass package:
3
Verify that the part numbers on the package match the numbers on your
purchase order, packing slip or tagging information.
3
Check the unit for physical damage which may have occurred during
shipping. If any part of the package is missing or damaged, notify the
carrier and your Nidec Control Techniques representative immediately.
3
Verify that all internal hardware (i.e. components, screws, etc.) is properly
seated and fastened securely.
2.2 Nameplate Information
The HMI bypass package has two nameplates for identification. The main
label is located on the inside of the enclosure. This nameplate provides
information on the entire package. The second nameplate is located on
the VFD. This nameplate contains information related to the VFD only. The
nameplate information should be recorded and kept in a safe location. This
information is required for any service or repair.
2.2.1 Labels
2.2.1.1 HMI Bypass Package Label