Nidec Control Techniques HVAC Drive H300 HMI Bypass, Installation And Commissioning Manual

Page: 9 / 56

HMI Bypass Controller Installation and Commissioning Guide 9
2.4 Mounting & Clearances
Install the HMI bypass package on a vertical surface and allow the following
minimum clearances for normal heat dissipation.
WARNING
WARNING
Potentially hazardous voltage
can exist within this device. Only fully trained, qualified personnel should
service this equipment.
Pressing the stop button will not remove power from this equipment.
Never service this equipment without first being sure all power is safely
removed. Hazardous voltage levels may exist for up to 5 minutes after
power is disconnected!
WARNING
WARNING
Potentially hazardous voltage
can exist within this device. Only fully trained, qualified personnel should service this equipment.
Pressing the stop button will not remove power from this equipment.
Never service this equipment without first being sure all power is safely
removed. Hazardous voltage levels may exist for up to 5 minutes after power is disconnected!
12 in
6 in 12 in 6 in
TOP SIDE-TO-SIDE
Air Flow
Notes:
• Ambient operating temperature; 32 °F to 104 °F (0 °C to 40 °C)
• Install the unit in a dry environment free from oil mist and dust
• Install the unit in a location free from radioactive materials, combustible
materials, harmful gases or liquids
• Do not install the unit in a location susceptible to excessive vibrations
• Do not install in direct sunlight
• During installation, protect the unit from foreign particles such as metal
shavings produced by drilling
• Failure to follow these notes could void the warranty