NF FRA5087, Instruction Manual

Page: 94 / 194

4.6 Display setting
FRA5087
4-20
！
CAUTION
It can happen that the data read out from the USB flash drive cannot be loaded
into the memory due to insufficient capacity of the memory, when the data
volume of the file to be read out from the USB flash drive is too large. Take
the following measures when the memory capacity is insufficient for loading
the data:
1) Delete unnecessary data in the mass memory.
2) If you have any data that have not yet been stored in the master memory
since the data have just been taken, and if those data are unnecessary for
you, press the function key [DELETE CUR.TAG] in the menu [Memory]
to delete the data.
If you find you cannot yet load the data from the USB flash drive even after
you have taken the measures above, record and store into the permanent
memory or the USB flash drive all those data that are in the mass memory and
also those data that have not yet been stored in either the mass memory or the
permanent memory, which have been left as measured. Then, switch off the
power supply of the FRA 5087 and switch it on again to load the data from the
USB flash drive.