NF FRA5014, Instruction Manual

Page: 87 / 107

6.1 Error Displays
FRA5014 6-3
6.1.2 Remote control errors
Error
No.
Error message Cause(s) of error
0 “No error” No error
<Syntax errors>
−
100 “Command error”
An invalid command was received (no specific type).
−
102 “Syntax error”
An undefined command or parameter was received.
−
110 “Command header error”
Command header was recognized as invalid.
−
111 “Header separator error”
Header separator was not detected when parsing header.
<Execution-related errors>
−
200 “Execution error”
An error occurred when executing a command (no
specific type).
−
222 “Data out of range”
Command’s parameter is outside of setting range.
−
340 “Calibration failed”
Calibration failed.
−
350 “Queue overflow”
A newly occurred error cannot be retained due to error
queue overflow.
−
370 “Invalid (max<=min)”
Settings enabled as upper limit and lower limit settings
were reversed.
−
371 “OSC AC+DC > +/
−
10.5 V”
Oscillator’s output voltage peak is too high, so normal
signal output is not possible.
−
372 “OSC ac output = off”
Attempted to measure during zero AC output
−
373 “OSC is on”
Oscillator is ON; cannot execute self calibration
−
377 “In Calibrating”
Attempted to measure during calibration
−
378 “In Measuring”
Attempted calibration, etc., during measurement
−
381 “CH1 Overload”
Overload occurred in CH1
−
382 “CH2 Overload”
Overload occurred in CH2
−
383 “CH3 Overload”
Overload occurred in CH3
−
384 “CH4 Overload”
Overload occurred in CH4
* The error queue has four stages. If the error queue becomes full and another error occurs, error
350 (“Queue overflow”) is inserted at the end of the queue.