NF FRA5014, Instruction Manual

Page: 59 / 107

5.3 Command Tree
FRA5014 5-11
5.3 Command Tree
Figure 5-2 below shows the FRA5014
’s subsystem command tree.
CALibration [ALL]
SENSe DATA SWEep [DATA] [ALL]
[DATA] SELected
POINt
SPOT [DATA] [ALL]
[DATA] COMPlex
[DATA] SELected
LIMit GAIN MAXimum
MINimum
PHASe MAXimum
MINimum
REPort [ALL]
SELected
INPut(1|2|3|4) VOLTage OVERload [LEVel]
RESPonse
GAIN
MEASure DELay [TIME]
INTegrate CYCle
TIME
[SOURce] FREQuency [IMMediate]
SWEep MEASure
SPACing [TYPE]
POINt
[LEVel] MAXimum
MINimum
VOLTage OUTPut [STATe]
OFFSet [IMMediate]
[LEVel] [IMMediate] [AMPLitude]
UNIT
STATus OPERation CONDition
ENABle
[EVENt]
NTRansition
PTRansition
OVERload ENABle
[EVENt]
SYSTem
ERRor
OVERload RELease
Figure 5-2. Command Tree
Square brackets ([ ]) indicate parts
of key words that can be omitted.