UW-8 Plug Pinout
Sensors can be connected to the
of NexSens X2 and G2-Series by installation of a UW-8
plug connector on the end of a sensor cable. The pinout for the UW-8 plug connectors is as follows:
Pin #
SensorBUS Signal
Wire Color
1
RS-232 Tx*
Orange
2
GND
Black
3
RS-232 Rx*
Yellow
4
5V Power
White
5
12V Power
Red
6
SDI-12
Brown
7
RS-485 B
Blue
8
RS-485 A
Green
*RS-232 transmit/receive is labeled from the data logger’s perspective (should be wired to sensor’s
receive/transmit, respectively).
UW-8 plug connectors are usually factory installed onto sensor cables (part number
). This ensures
that all signal wires are connected to the appropriate pins, and the connectors are sealed with epoxy to provide
fully waterproof connections. While this is critical for use on buoys (X2-CB, X2-SDL data loggers) and in other
wet environments, users may in some cases choose to install
).
NexSens UW-8 plug pinout.
62
Summary of Contents for X2-CB
