Section 8 — Optional Equipment
8 - 3
CAUTION
The ESP6000 controller card, terminal block board, and stages are
sensitive to static electricity. Wear a properly grounded anti-static
strap when handling equipment.
WARNING
Power-down personal computer or external power supply
before connecting any equipment.
For PC-based configurations, the terminal block board can be connected
any time after installation of the ESP6000 controller card, controller card
driver software, and Windows motion utility software is complete. First
power off the PC, then connect the terminal block board and cables/leads
and device(s).
8.1.2 Analog I/O Cable
The analog I/O cable is a 26-25 ribbon cable designed for use with the
ESP6000 controller card. The cable has an 8-channel analog signal capacity
for interfacing devices. Refer to the Windows Motion Utility Setup Hard-
ware sub-menu, Analog I/O tab to configure devices for use. The cable is
shown in Figure 8.1-2, connections are listed in Table 8.1-2., and connector
pin-outs and descriptions are provided in Appendix C.
N97117
Figure 8.1-2 — Analog I/O Cable
Table 8.1-2 — Analog I/O Cable Connections
ESP6000 Controller Card
To Device
Reference Designation
(D-Sub Connector)
JP2
Customer-specified
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
