© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
78
ELECTRICAL
This article provides brief operation instructions for a Glendinning Cablemaster Power Cord Reel (Model: CRR-50).
Glendinning Cablemaster Power Cord Reel
Operation (Model: CRR-50)
Cord Reels
This article provides an operational overview of the shore power cord reel and switch.
Cord reels (when equipped) provide the ease and convenience of storing the shore power electrical cord in a
neat and compact space with the assistance of motorized retraction. On coaches equipped with a power cord
reel, pull out the power cord, and plug it into an appropriately rated electrical outlet. Make sure the power source is providing
the correct voltage before plugging in the shore cord.
To store the cord, disconnect it from the power source outlet. Remove the cord from the pocket in the compartment, and press
and hold the momentary switch to retract and roll up the power cord as needed. The switch is typically located on the cord
reel or on the compartment door.
Operation
To extend the power cord:
1. Pull out su
ffi
cient cord length
that will allow you to route
shore power cord to the
electrical distribution box.
2. Plug the molded end into the
receptacle.
To retract the power cord:
1. Detach plug from receptacle
using lever on plug.
2. Press and hold the button and the power cord will
automatically retract (CAUTION — it is advisable to
monitor the progress of the power cord as it retracts
and stores onto the reel).
Maintenance
Experience has shown that when only a short section of
power cable is regularly used, the cable may be subject
to “kinking”. To relieve this condition, routinely extend
the power cable completely and stretch it on any smooth
surface. Allow the Cablemaster to retract the cable onto
the reel. At least once a year, inspect all AC and DC wiring
connections and make sure they are free of corrosion and
connections tight.
Periodically inspect the exterior jacket of the power cable
for nicks or cuts. If your power cable is dirty, any cleaner
should be compatible with the outer jacket material of the
power cable.].
Source(s): Cablemaster CRR-50 Manual: Installation and Operation
Instructions
Product(s): Glendinning Cablemaster 50 Amp Power Cord Reel w/50’
Power Cord (Model: CRR-50, Newmar Part Number: 116690)
On coaches built on a Ford chassis, batteries are normally
located in the front of the coach and can be accessed by
opening the hood.
On diesel coaches, the house batteries are normally
located in one of the lower compartments. The chassis
batteries are normally on the passenger side in the rear
compartment on diesel pushers and under the driver’s
side cab on the front engine on Super C coaches.
Cord Operation
Use only approved applicable outlets. Cord connector has
a built-in Easy-T-Pull handle for easy disconnect.
User Maintenance
This unit does not have any user serviceable parts. The
user can perform periodic inspection of the cord to insure
it is still in usable condition. DO NOT use if the cord is
damaged.
This article provides brief operation instructions for a TRC Shoreline Power Cord Reel (Model: RH5)
TRC Shoreline Power Cord Reel Operation (Model: RH5)
This unit is designed with a clutch type
drive to allow direct engagement during
retract and clutch disengagement to
allow for free spooling during release.
These features are controlled using
the rocker switch assembly MH2021,
RV2100, or equivalent previously
installed.
To correctly operate the unit, follow the
steps listed below. If the unit does not
perform according to the instructions below, first recheck
wiring for any issues
Summary of Contents for VENTANA 2022
Page 1: ...SM 2022...
