© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
166
HVAC
CH50
NE-S
CHINOOK
BTU
50,000
85,000
50,000
Maximum Water Temperature (at
incoming water temperature of 60°F)
120°F
120°F
120°F
Gallons Per Minute (GPM)
1.5
3.0
1.5
Potable Hot Water Capacity
Domestic Hot Water via Oasis Hydronic Heating
The hot water in your coach is heated by the Oasis hydronic heating system. To operate an appliance that uses hot water,
or to assure plenty of hot water for showering, turn on
the boiler or heating elements using the Oasis control
panel or the SilverLeaf touchscreen (if equipped) located
in the front overhead cabinet.
Both heat sources (diesel burner and heating elements)
can be used at the same time for the maximum water
heating capability. Turning only the 120 volt heating
element(s) on will usually provide su
ffi
cient hot water
for most household chores, but may not be su
ffi
cient for
showering.
The diesel burner is the primary heat source with at
least 50,000 btu (more on select Oasis models), and the
electric elements are secondary. Depending on your hot
water usage, using only the electric elements may be
su
ffi
cient; however, if not, use the diesel burner when
not plugged into shore power or in conjunction with the
electric elements.
This article provides an overview for radiant heating (floor heat). The floor heat uses a heat mat placed
between the tile and the floor structure. A controller regulates the temperature and the timed heat cycles
depending on the controls set up for your system. The floor heat operates on 120 volt AC power.
Radiant Heating
KIB Floor Heat Switch Overview
This article provides an operational overview of the KIB floor heat switch. This article contains written information, as well
as a video produced by Newmar.
Press the Bed, Kitchen, or Bath ( Forward, Mid, Aft) floor
heat button once to activate the floor heat. Press the
button again to scroll through the settings:
•
High
•
Medium
•
Low
•
O
ff
The di
ff
erent settings have specific time intervals of
on and o
ff
for heating. The heating indicator LED will
illuminate when voltage is being sent to the heating
element. For floor heat operation, 120 volts must be
present from shore power or the generator.
If your coach is equipped with the SilverLeaf coach management system, refer to the SilverLeaf functional guide for more
information about the function and operation of the floor heat via the SilverLeaf touchscreen.
CAUTION
!
Per the Aries Engineering (Gold Heat) Radiant Floor
Heat Installation Instructions and Owner’s Manual,
“Don’t place rubber backed area or throw rugs over
the heated area to avoid excessive heat from building
in these areas.”
Keep your coach comfortable no matter where you are. Whether it’s cold or hot outside, on the inside, you
will always be “just right” using your coach’s thermostat.
Thermostats
Summary of Contents for VENTANA 2022
Page 1: ...SM 2022...