© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
193
PLUMBING
REMOVING THE ACCESS DOOR
1. Open the access door to Position 2.
2. Move the access door upwards to remove it.
CLOSING THE ACCESS DOOR
Damage to the access door and the RV if the access
door is not closed properly! Make sure that the access
door is flush with the cover plate when closed.
NOTICE
!
WARNING
!
Danger of over-temperature and toxic exhaust
gases! Use with LP gas (propane) only. Butane or any
mixtures containing more than 10 % butane must not
be used. Keep the air inlet and exhaust gas outlet
free of obstructions. Do not lean any objects against
the water heater’s access door or place any foreign
objects within 2 feet (61 cm) of the access door.
Inspections Before Each Use
Check the appliance for the following points before each
use. In case of damage, contact an authorized Truma
service provider and do not operate the appliance.
1. Check for visible damage, e.g., on the cover plate or
access door.
2. Provide adequate quantities of propane gas and fresh
water.
3. Switch ON and check 12 V power supply of your RV.
4. Check that the access door of the appliance is closed.
5. Keep the appliance free of foreign objects, e.g.,
leaves, animals, spiderwebs, and keep the area
around free of snow and ice. The appliance will not
function properly if the intake air or exhaust terminal
is obstructed.
Operating Procedures
Proceed as follows to fill the appliance with water:
1. Close open bypass lines (if present). Insert the water
inlet filter or heating cartridge
–
if removed. 2, 7, 9
–
11.
2. Turn on fresh water supply or switch on water pump.
3. Fill the plumbing system.
•
Open all water-release points, e.g., cold and hot
water faucets, showers, toilets.
•
It is important that you bleed the water system
before starting the appliance.
•
Once water flows, the plumbing system is vented.
Close the water-release points.
4. Start the appliance as follows:
•
Make sure that the LP gas supply is turned on.
•
Switch on the 12 V power supply (RV).
•
Open the access door.
•
Switch on the appliance at the POWER switch.
WARNING
!
Danger of combustion, personal injury and damage
to RV! Keep the area around the appliance free from
combustible materials, gasoline, and other flammable
vapors or liquids. Switch the gas supply and the
appliance o
ff
: if anything seems to be out of the
ordinary, if you smell gas, if you move the RV, before
entering a gas station, before entering a tunnel.
Risk of damage in frost conditions. In frost conditions,
ambient temperatures below 39 °F (4 °C), there is a
risk that water in pipes, faucets and appliances could
freeze. This can cause considerable damage. Before
you fill water into appliances and parts that transport
water, you must heat the installation area su
ffi
ciently
so that the water cannot freeze.
NOTICE
!
1. If removed, insert the access door into the cover
plate.
2. Make sure that the webbing is not pinched between
the access door and the cover plate.
3. Press the access door against the cover plate.
4. Turn the turn lock clockwise into the horizontal
position.
Summary of Contents for VENTANA 2022
Page 1: ...SM 2022...
