© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
139
ENTERTAINMENT SYSTEMS
AUTO POWER OFF
If there is no signal input in any mode, the TV
will automatically access the standby state after
approximately 15 minutes.
MEMORY BEFORE TURNING TV OFF
The settings of picture and the preset channels will be
memorized at turning o
ff
the unit. When it is started up
again, the unit will work according to the mode set before
being turned o
ff
.
DVD Operation
1. Press the Eject (
▲
) button on the
side panel or on the remote.
2. After placing a disc in the disc tray,
press the
⊲
||
button to play the
disk, and press the
⊲
||
button twice
to pause the disk.
Television Lifts
Television Lift Operation via Control Switch
This article provides basic operation instructions for a television lift (televator) via a control switch.
Operation
1. Press and release the Televator Switch to move the
lift in the desired direction.
2. The lift will continue in the selected direction until it
reaches the end of travel. If you need to stop it at any
time during the travel process, press the switch again
in either direction.
3. Under normal operation, the user will raise the
televator to watch the TV, then lower it before
traveling. However, when raising the televator and
then immediately lowering it, the switch may need to
be pressed a second time, as the control circuit timer
may still be active.
Basic Operation
TURNING THE TV ON OR OFF
1. After attaching cable to either an antenna or a cable
service, insert the power cord plug into a polarize AC
outlet.
2. Press the POWER button on the LED TV.
3. The normal picture will be displayed on the screen
after six seconds. If no signal, “No Signal” will display
on the screen.
4. If temporary POWER of is required, press the POWER
button on the LED TV.
5. If you want to completely switch o
ff
the power for this
unit, unplug the power cord plug.
6. After switching o
ff
the unit, you should turn on the TV
again at least five seconds later.
STATUS INDICATION LAMP
1. Green: In power on mode.
2. Red: In standby mode.
Source(s): Skyworth LED HD TV/DVD Combo User’s Manual
Product(s): Skyworth 19” LED HDT TV/DVD Combo (Model: SLC-1921A-
3S, Newmar Part Number: 145572)
Televator control switches and touchscreen buttons
should be pressed and immediately released. Do not
continue to hold the UP or DOWN switch or button,
as this may cause the television lift to enter into
programming mode.
NOTICE
!
Note: If programming mode is reached, refer to the re-
calibration article in Newgle for more information.
Televator During Travel
Lower the television lift completely for travel to
prevent damage to the television and surrounding
equipment.
IMPORTANT
!
Summary of Contents for VENTANA 2022
Page 1: ...SM 2022...
