NEW BRUNSWICK SCIENTIFIC BioFlo 4500, Manual To Operations

Page: 74 / 214

BioFlo 4500 M1254-0050 User’s Guide
74
5. Enter the loop name you wish to add in the space provided using the onscreen
keyboard.
6. If you wish to change the name before pressing
OK
, press the
CLEAR BUTTON
.
This will clear the content of the loop name. Press
OK
to accept the loop name.
7. The
LOOP CONFIGURATION SCREEN
will appear. You may proceed to the
next section (section 9.2) to finish configuring the loop.
8. If you cancel the
LOOP CONFIGURATION SCREEN
, the loop will not be added.
To add the loop, press
OK
.
9. To leave the
MAIN CONFIGURATION SCREEN
press the
CLOSE BUTTON
. A
DISPLAY GAUGE
will appear in the
GAUGE SCREEN
with the loop name that
was just added.
9.2 Configuring Control Loops
Configuring each control loop consists of specifying its controller output, input,
and display characteristics, and identifying the terminals used to connect the input
from the loop sensor, and the output to the loop actuator.
To configure a new control loop or to modify a previously configured control
loop:
1. Press the
CONFIG BUTTON
in the
GAUGE SCREEN
.
2. The
MAIN
CONFIGURATION SCREEN
will appear.
3. In the
LOOPS WINDOW
, touch the loop that you wish to configure.