NV-600WI Managed Industrial Grade Wireless VDSL2 Router USER’S MANUAL Ver. A2
243
9. Question:
What can I do if I forgot my password?
Answer:
If you forgot your password, you must reset your router. This process will change all your settings
back to the factory default. To reset the router, locate the reset button on the rear panel of the unit.
With the router powered on, use a paperclip to hold the button down for over 5 seconds. Release the
button and the router will go through its reboot process. The default IP is 192.168.1.1. When logging
in, the default username and password are both “
admin
”.
10. Question:
Is it possible to use ADSL2 IP DSLAM with the NV-600WI?
Answer:
NV-600WI support the ADSL Annex B backward compatible, therefore the NV-600WI can connect to
ADSL2 IP DSLAM.
11. Question:
I have purchased a kit of NV600L and NV600W to extend the property WiFi network. They will sit in
the property LAN which is served by a modem router and off an ADSL telecom connection. Each NV
unit will have a fixed IP LAN address. All WiFi user addresses are provided by the gateway modem
router. The reason for purchase is to extend the LAN service via phone lines to the WiFi access point.
I would appreciate a simple configure set up for each unit. e.g. should the 600L be configured as a
switch or router?. Do I need to configure a VDSL2 WAN between the 600L and 600W?
Answer:
Basically, use default settings that the network can be established. NV-600L should configure to
switch mode (default mode), and NV-600W configure to router mode (default mode).
12. Question:
What is the maximum Ethernet frame MTU for these routers?
Answer:
NV-600WI maximum Ethernet frame MTU is 1680 bytes.
