NV-600WI Managed Industrial Grade Wireless VDSL2 Router USER’S MANUAL Ver. A2
14
2.5 Connecting the RJ-11 / RJ-45 Ports
The line port has 2 connectors: RJ-11 and terminal block. It is used to connect with NV-600L (CO) using a single pair phone
cable to NV-600WI (CPE) bridge side (point to point solution). Take note that NV-600WI line port RJ-11 and terminal block
cannot be used at the same time. Either RJ-11 port is connected or terminal block is connected using straight connection.
(
Figure 2.5
).
Figure 2.5
NV-600WI line ports straight connection
When inserting a RJ-11 plug, make sure the tab on the plug
clicks into position to ensure that it is properly seated.
Do not
plug a RJ-11 phone jack connector into the Ethernet
port (RJ-45 port). This may damage the router. Instead, use
only twisted-pair cables with RJ-45 connectors that conform to
Ethernet standard.
Notes:
1.
Be sure each twisted-pair cable (RJ-45 Ethernet cable) does
not exceed 100 meters (333 feet).
2.
We advise using Category 5~7 UTP/STP cables for making
Bridge or Router connections to avoid any confusion or
inconvenience in the future when you attach high bandwidth
devices.
3.
Use
24 ~ 26
gauge twisted pair phone wiring, we do not
recommend 28 gauge or above.
4.
Be sure phone wire has been installed before the NV-600WI
boot.
