Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
Port and System Setup Commands
4-11
v1.0, February 2007
4.3 Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system time
and date by using SNTP.
4.3.1 sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of
two where <poll-interval> can be a value from 6 to 16.
Default
6
Format
sntp broadcast client poll-interval <poll-inter-
val>
Mode
Global Config
4.3.1.1 no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Format
no sntp broadcast client poll-interval
Mode
Global Config
4.3.2 sntp client mode
This command enables Simple Network Time Protocol (SNTP) client mode and may set
the mode to either broadcast or unicast.
Default
disabled
Format
sntp client mode [broadcast | unicast]
Mode
Global Config
4.3.2.1 sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format
no sntp client mode
Mode
Global Config
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
