Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
14-16
Quality of Service (QoS) Commands
v1.0, February 2007
14.3.13 match protocol
This command adds to the specified class definition a match condition based on the value
of the IP Protocol field in a packet using a single keyword notation or a numeric value
notation.
To specify the match condition using a single keyword notation, the value for <
protocol-
name
>
is one of the supported protocol name keywords. The currently supported values are:
icmp, igmp, ip, tcp, udp
. A value of ip is matches all protocol number values.
To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
Format
match protocol {protocol-name | <0-255>}
Mode
Class-Map Config
14.3.14 match source-address mac
This command adds to the specified class definition a match condition based on the source
MAC address of a packet. The <address
>
parameter is any layer 2 MAC address formatted
as six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The
<macmask
>
parameter is a layer 2 MAC address bit mask, which may not be contiguous,
and is formatted as six, two-digit hexadecimal numbers separated by colons (e.g.,
ff:07:23:ff:fe:dc).
Default
none
Format
match source-address mac
<address> <macmask>
Mode
Class-Map Config
14.3.15 match srcip
This command adds to the specified class definition a match condition based on the source
IP address of a packet. The
<ipaddr>
parameter specifies an IP address. The
<ipmask>
parameter specifies an IP address bit mask and must consist of a contiguous set of leading
1 bits.
Format
match srcip <ipaddr> <ipmask>
Mode
Class-Map Config
Note:
This command does not validate the protocol number value against the
current list defined by IANA.
Summary of Contents for GSM7224 - Switch
Page 4: ...v1 0 February 2007 iv...
Page 20: ...xx v1 0 February 2007...
