101-092 49
FINGER007
–
Version 4.0
IDTeck – FINGER007 FINGERPRINT & PROXIMITY READER
9.4.7 INPUT TEST
9.4.8 COMMUNICATION TEST
9.4.9 CHECK FINGERPRINT DARKNESS
9.4.10 SET FINGERPRINT DARKNESS
INPUT TEST
☞
. To test performance of input ports, press <ENT> key.
The lower line on the LCD indicates the status of the five input signals.
Note
:
1. Input 1~4
−
<1>
: No input signal,
<0>
: Exist input signal
2. Input 5
−
<0>
: No input signal,
<1>
: Exist input signal
INPUT TEST
COMM TEST
☞
. To test performance of input ports, press
<ENT>
key.
(
Before this communication test, connect the RS-232 RX, TX wires
to each other.
)
If there is a problem with the communication performance, check
connections and try again.
As the test proceeds, you can see the characters being transmitted and
received. Finally LCD display communication test pass message.
COMM test pass !!
TX data = 0
GET GAIN in FDA
☞
. You can see the current fingerprint darkness for scan.
The gain is the higher, scan fingerprint is the dark.
CAUTION
: Fingerprint darkness gain and fingerprint certification ration is not
always direct proportion.
SET GAIN in FDA
☞
. You can adjust the fingerprint darkness at this menu. Press <ENT> key
to adjust the fingerprint darkness. You can 1,2,4(default) or 8 as the value.
