101-092 33
FINGER007
–
Version 4.0
IDTeck – FINGER007 FINGERPRINT & PROXIMITY READER
9.1.7 BAUD RATE SETTING
☞
.
FINGER007
supports 4800, 9600 and 19200 of baud rate and default
setting is 9600bps. Wrong baud rate setting will cause communication
errors and you have to set same baud rate to
FINGER007
and host PC.
If you have communication problem, please check followings;
- Check COMM ID of
FINGER007
and host PC
- Check BAUD RATE of
FINGER007
and host PC
- Check communication port and cable
- Check COM port set-up of host PC
Parity: None, Data Bit: 8 bit, Stop Bit: 1 bit
To change the baud rate, press
<ENT>
key and select desired baud rate
by pressing
<4>
or
<6>
key then press
<ENT>
key.
BAUD RATE
BAUD RATE
BAUD RATE
9.1.8 EVENT CLEAR
☞
. You can clear the event memory in this menu. Press
<ENT>
key then
press
<1>
key to clear event memory or
<0>
key to cancel the operation
CAUTION : Before you clear the events, make sure that the stored
events is not necessary to upload to the host PC otherwise you may
lose important data.
EVENT CLEAR
EVENT CLEAR
9.1.9 MASTER ID CHANGE
☞
. If you select 2 (Key)
FINGER007
is waiting for a keypad which is to be
registered.
FINGER007
: 4 or 8 digits,
FINGER007SR
: 10 digits
( “0000000001” ~ “4294967295” ),
INPUT NEW
☞
. If you select 1 (Card)
FINGER007
is waiting for an RF card which is to be
registered. The card number will appear with a beep as the card is read.
Scanning …
CARD & Key Use
☞
. Press
<ENT>
key to change the current Master ID. You should use the new
Master ID to access the SETUP MENU after you changed the Master ID.
Default Master ID / PW
FINGER007
: “00000000”/”3141”
FINGER007SR
“0000000000”/”3141”
MASTER ID
