101-092 35
FINGER007
–
Version 4.0
IDTeck – FINGER007 FINGERPRINT & PROXIMITY READER
9.1.10 SYSTEM INITIALIZE
`
9.1.11 CARD ID CLEAR
9.1.12 TIME SCHEDULE CLEAR
9.1.13 KEYPAD INPUT SETTING
Time Sche Clear
RF_PIN_INPUT
RF_PIN_INPUT
☞
. You can enable PIN(card number) to be input through the keypad, so
that someone who doesn't carry RF cards with him can access the door.
When it is disabled, accessing the door by keypad will be denied.
Press
<ENT>
key to toggle the mode.
CAUTION:
The default Master number,
“00000000”
, must be replaced
with a new Master card number before disabling keypad input, or
you
CANNOT
access the set-up menu again.
In case of that, the only thing you can do is hardware initialising.
Do not use
this menu in
FINGER007P
.
SYS INITIALIZE
Sys Initialising
System
☞
. This operation will initialise the
FINGER007
. Press
<ENT>
key, if an
initialisation is needed. (First time installation or resetting in the event of a
malfunction)
A
fter the initialisation,
FINGER007
will return to the set-up menu
.
CAUTION : Initialising will erase all stored data in the memory
.
(ID, EVENT, T/S, In/Out define, etc...)
Card ID Clear
CARD ID CLEAR
☞
.
When you want to delete all User ID (Card ID), you can clear all User ID
from the memory. Press <ENT> key then press <1> key to clear all User
ID or <0> key to cancel the operation.
CAUTION
: Before you clear all User ID, make sure that the
registered User ID is no longer used otherwise you may lose
all registered User ID.
TIME SCHE CLEAR
☞
. When you want to delete all Time Schedule (01~1
0
), you can clear all T/S
from the memory. Press <ENT> key then press <1> key to clear all T/S
or <0> key to cancel the operation.
CAUTION
: Before you clear all T/S, make sure that the stored T/S
is
no longer used otherwise you may lose all stored T/S in the
memory.
