71
select to inspect its actual rotation angle by checking [Inspect Angle Offset]. If it exceeds the set
allowable rotation angle, it will be reported NG. Selecting this function will slightly increase the
inspection time.
Save log file: if special system problems need to be eliminated, the user can choose to save the log
file and hand it over to the supplier for technical analysis.
Close Beep On InspectNG: if the user's machine is equipped with sound, the user can choose to turn
off or turn on the sound effect. This equipment is generally not applicable.
Automatic double track recognition: this option is used for double track online machine. When the
double track calling program is checked, it will prompt the use track of the current program. During
the inspection, it is unnecessary to inspect ID Mark and directly call the inspection program according
to the track, thus saving the inspection time.
Automatically save PCB thumbnail: when saving PCB data, the thumbnail of each board will be
saved.
Synchro Move of Panel: when checked, if moving the component frame of PCB, the same component
frame on other spilts will also move at the same time.
0201/0402 split inspection: when checked, [split inspection] will be automatically checked when
[0201] and [0402] frames are used for making frames during program editing.
Machine Folder Drive: the user can choose to set the operating system drive letter and folder number
of the program file storage. For example, if D and 1 are selected, the program files will be stored
under D:\Machine_1\, and stored hierarchically according to the model and file name.
Auto Save: the system automatic saving time setting can remind users to save program files within a
fixed time, so as to avoid the loss of the program being edited when the machine is shut down due to
special software and hardware reasons.
Mode: the system also provides special mode settings for non-standard system users, which can be
ignored by standard system users.
In [Editing Mode], open [User Management] in [System Configuration] in the menu bar, as shown
below: