59
and back sides of PCB board.
After debugging the program with false positives, enter [Set PCB-ID Mark] from [Base
Board Configuration] in the menu bar, as shown below:
Then, select a fixed image from the whole PCB board, box it in the fact image on the left side of
the interface, and click [Set], as shown above. (Note: a clear and stable image should be selected,
and the same image cannot be found at the same position on the other side of the PCB.) Click
[Close] after setting, and then click [Save] in [File Management] in the menu bar.
Then, click [set PCB-ID Mark] for the program on the other side in the same way. The following
interface will be prompted when reopening the program with the set ID Mark, as shown in the
following figure: