49
First, check [Image to be Inspected] to switch to the image to be inspected. Then check whether
each pin in the upper part of this interface is clearly divided and whether there is foreign matter
in the middle, and then debug and divide the pins by [Area Threshold] and [Division Threshold]
until each pin is clearly divided, then click [Save] to return to the upper interface and click
[Close].
Where the component frame is offset, as shown in the following figure:
The offset of a single component frame can be realized by the arrow at the top of the picture. If
most component frames are offset, you can click [Move to Current Component]-[Enter Editing
Mode] in the middle of the lower part of the interface, and then you will enter editing mode. The
camera will automatically move to the currently shifted component and then adjust the position.
After adjustment, click [Working Mode]-[Inspection Mode] in the menu bar and then click [NG]
in the figure to return to the current false alarm interface, as shown below: