58
After entering this interface, check the same image defined in [New Area] on diagonal spilt (i.e.,
spilt in the upper right corner), and then enter the corresponding numerical value in front of
[Copy] at the bottom of the interface according to the spilt arrangement. (Note: the new area
shall prevail. Enter the number of areas on the right and the top, and the number of the new area
is not counted). Then click [Copy], as shown in the following figure:
Then click [Yes] as shown in the following figure:
Click [Exit]. After editing, each single spilt will automatically generate a yellow dotted frame on
the thumbnail on the right. Then click [Save] in [File Management].
If there are spilts of different angles (yin and yang boards) on the PCB board, the operation of
spilts of the same angle should be done first according to the above steps. Then, the operation of
spilts of another angle should be started from [New Area] until it is finished.
8.5 Setting of ID mark
This function is used to inspect the front and back sides of PCB board at the same time, and
two programs can be adjusted at the same time. When AOI inspects the board, the corresponding
programs can be called for inspection by identifying different identification points on the front