24
First, click [Track Width Adjustment] in [System Configuration] in the menu bar, as shown in the
following figure: (this figure is NeoDen 880)
Select the corresponding track in this interface, and adjust the width of the track through
[Up] and [Down] on the keyboard. (Note: Track 1 is fixed and not adjustable, and only Track 2
can be adjusted for the lower cover and monorail.) You can select [Jog] and then select the
corresponding unit for fine adjustment. Click [Close] after the adjustment is completed
Then put the board on the corresponding track, and check [Front Track] or [Back Track] in
the menu bar of the double track machine to switch. Put the PCB on the entry end of the track,
and click [Enter Board] at the bottom of the interface. The PCB enters the normal inspection
position in the track and is fixed.